Paya Move 5000 -- WiFi Setup
Get the Move 5000 onto your WiFi network in 10 steps.
Move 5000 only.
Doing this on terminals other than the Move 5000 will not be supported. All other terminals must be on Ethernet -- see Paya Ethernet Setup.
- 1
Power on the terminal.
- 2
Once at the "Powered by Paya" screen, press 2, 6, 3, 4.
- 3
It will prompt you to press the Function Key. This is the silver key with the circle.
- 4
The screen is touchscreen -- select "Tetra Admin".
- 5
Select "Scan WiFi".
- 6
Select the WiFi network you want to use.
- 7
Enter the password.
- 8
Press the red Cancel key to get back to the Admin screen.
- 9
Make sure the WiFi icon changes from gray to green. Green = good connection. If it stays gray, go back and recheck the password.
- 10
Press and hold the # and Yellow keys until the machine reboots.
Test the connection
Once you are back at the "Powered by Paya" screen, send a test sale to the terminal via the Virtual Terminal at hellasbae.payaconnect.com.
Terminal still not connecting?
Run through the four-test diagnostic flow, or message your CC thread on WhatsApp.